Hey guys.
Really nice forum here. Have used it a lot!
Now I hope you can help me out here a little, since I cant find the answer already.
I was trying to update my hex-net firmware using the config.jar. It was looking fine until the program crashed at around 30-40% in.
Now my interface is blinking 6 times in the green led1, and then goes to constant red blinking in the red led1. (2 and 3 never turns on.)
I can connect to the interface in both vcds mobile on my tablet, and in hexnetconfig but the interface doesnt work.
I am pretty confused with the current versions on the interface, since they dont really match any numbers on the forums that Uwe posted:
CB: 21.46615
FW: 0.254
CFB: 0.10
BL: 0.28
DS: 00000000
Do you have any suggestions? Or is the interface toast?
I already tried to reset with the button down while connecting the usb.
-Fuglsang.
Really nice forum here. Have used it a lot!
Now I hope you can help me out here a little, since I cant find the answer already.
I was trying to update my hex-net firmware using the config.jar. It was looking fine until the program crashed at around 30-40% in.
Now my interface is blinking 6 times in the green led1, and then goes to constant red blinking in the red led1. (2 and 3 never turns on.)
I can connect to the interface in both vcds mobile on my tablet, and in hexnetconfig but the interface doesnt work.
I am pretty confused with the current versions on the interface, since they dont really match any numbers on the forums that Uwe posted:
CB: 21.46615
FW: 0.254
CFB: 0.10
BL: 0.28
DS: 00000000
Do you have any suggestions? Or is the interface toast?
I already tried to reset with the button down while connecting the usb.
-Fuglsang.