Uwe

I would be very surprised if VCDS was of any use with this at all on a 2017 Crafter. -Uwe-

How warm was the engine? How long did you watch the pressure? -Uwe-

It's not a question of more software, your old Mac was Intel and your new one is ARM, so the drivers simply don't exist. If you want to...

I wish I had some more ideas for you, but I don't, sorry. -Uwe-

First thing you need to test turbo actuator , use vacuum pump and see will it hold vacuum. If not , you need new actuator.

Best get a wiring diagram and check that the modules that don't talk are getting power. -Uwe-

Please post an Auto-Scan for context. -Uwe-

Where exactly is "here"? ;) -Uwe-

I can't take credit... that's @DrPeter's awesome content.

Your contact information does not match what HN2-xxx852 is registered under. Please explain. -Uwe-

I moved the posts from the thread with subject Angle brackets shows only 0000/0000 while trying to do basis setting no target values...

When I say post readiness details, I mean similar to this Readiness Status: 10000010 00001111 11101011 00000000 MIL Status: MIL ON...

Your readiness is more than likely what the issue is.... go into that and post the details. One of your flaps appears to also be getting...

That's my point, there aren't any complaints about the DPF in the scan, and if the DPF was actually a problem, I'd expect there would be...

In the future, please do not use the [Print] function in VCDS to post data here. It's much harder to read than the native text that...